General discussions about Solo
Moderator: Mike Simanyi
Steve Collins
Posts: 164 Joined: Thu May 15, 2008 11:26 am
Club: SCNAX
Car#: 799
Post
by Steve Collins » Tue May 27, 2008 9:16 am
A co-worker wants to get some performance suspension work done on her Ford Focus.
Somewhere near Pasadena would probably be groovy.
It is a Ford Focus 2005, need to install Racing camber plates set to -2.5
and I need a rear sway bar installed. I need my alighment set to 1/16 toe in
the front and 0 toe in the rear with max camber at all four wheels.
Thanks,
Steve Collins
Steve Ekstrand
Solo Safety Steward
Posts: 7482 Joined: Thu May 15, 2008 11:26 am
Club: CASOC
Car#: 15
Location: This space left intentionally blank
Contact:
Post
by Steve Ekstrand » Tue May 27, 2008 9:58 am
Don't know a place.
But does she really want 1/16" toe in on the front?
Dr. Conemangler
aka The Malefic One
2015 Wildcat Honda F600
Steve Ekstrand
Solo Safety Steward
Posts: 7482 Joined: Thu May 15, 2008 11:26 am
Club: CASOC
Car#: 15
Location: This space left intentionally blank
Contact:
Post
by Steve Ekstrand » Tue May 27, 2008 11:40 am
+1 for Art's shop. Sorry for forgetting about it.
Close to Pasadena too.
Dr. Conemangler
aka The Malefic One
2015 Wildcat Honda F600
Mako Koiwai
Posts: 6490 Joined: Thu May 15, 2008 11:25 am
Club: SCNAX
Car#: 34
Location: South Pasadena, CA
Contact:
Post
by Mako Koiwai » Tue May 27, 2008 3:05 pm
++ for Art's
Does she really want a REAR sway bar, ie. stock = only front bar ... if she's going to come play with us.
Steve Lepper
Posts: 372 Joined: Thu May 15, 2008 11:25 am
Club: TCC
Car#: 355
Location: Orange, CA
Contact:
Post
by Steve Lepper » Tue May 27, 2008 4:58 pm
If she's installing camber plates she's not going to be in stock so a rear bar is a possibility.
Scott Kulbeck
Posts: 6 Joined: Thu May 15, 2008 11:26 am
Post
by Scott Kulbeck » Tue May 27, 2008 8:56 pm
Art's good, if he's not avaliable the guy that did George's engine in his Honda does that type of work also. Jimmy Jue, JueMotors 678 San Bernardino Rd., Covina 626-926-4908. He also has an alignment machine, one stop shopping.
Steve Collins
Posts: 164 Joined: Thu May 15, 2008 11:26 am
Club: SCNAX
Car#: 799
Post
by Steve Collins » Thu May 29, 2008 9:44 am
She's taking the car to Art Rinner. She's apparently setting it up as some kind of track-day M3 killer. Thanks for the advice gang.
Steve Collins